Pengaruh Penambahan Serbuk Galam Sebagai Pengganti Agregat Halus Pada Campuran Beton Mutu Normal
Abstract
The utilization of waste from wood cuttings is uncommon, and one of the wastes that is rarely employed is the leftovers of galam wood or galam powder cuttings. On this basis, a study entitled "The Effect of Adding Galam Powder as a Substitute for Fine Aggregate in Normal Quality Concrete Mixtures" was carried out. In this study, the experimental approach was used as the research method. The percentage of galam powder waste in fine aggregate, which can range from 0% to 30%, is the independent variable in this study. Other aggregates, such as cement, fine aggregate, coarse aggregate, and water, are the study's dependent variables. The compressive strength of 28-day-old material in the normal combination has a compressive strength of 22.23 MPa, the V10 mixture has a compressive strength of 4.58 MPa, the V20 mixture has a compressive strength of 3.11 MPa, and the V30 mixture has a compressive strength of 1.41 MPa. Based on the findings, it can be concluded that using waste galam powder as a fine aggregate alternative has not been successful since the galam powder does not bind completely to the concrete
Full text article
References
Adi, Prasetya. 2013. “Kajian Jenis Agregat Dan Proporsi Campuran Terhadap Kuat Tekan Dan Daya Tembus Beton Porus.” Jurnal Teknik 3(2):100–106.
Arif, Agustiono. 2020. “Pengaruh Abu Serbuk Kayu Sebagai Pengganti Agregat Halus Terhadap Kuat Tarik Belah Beton Yang Menggunakan Bahan Kimia.” Universitas Muhammadiyah Sumatera Utara.
Mulyono, Bagyo. 2006. “Program Komputer Untuk Perhitungan Kolom Beton Akibat Beban Aksial Tekan Dan Lentur Biaksial Pada Rangka Dengan Pengaku (Braced Frame) Dan Tanpa Pengaku (Sway Frame).” Dinamika Rekayasa 2(1):23–28.
Nugraha, Paul. 2007. “Teknologi Beton; Dari Material, Pembuatan, Ke Beton Kinerja Tinggi.”
Saifuddin, Muhammad Ikhsan, Bambang Edison, and Khairul Fahmi. 2013. “Pengaruh Penambahan Campuran Serbuk Kayu Terdahap Kuat Tekan Beton.”
Setiawan, Arman. 2018. “Studi Pengaruh Penggunaan Material Pasir Putih Baranti Terhadap Kekuatan Beton.”
SNI 2834. 1993. Tata Cara Pembuatan Rencana Campuran Beton Normal. SNI 03-2834-1992.
SNI 2834. 2000. Tata Cara Pembuatan Rencana Campuran Beton Normal.
Soebandono, Bagus, and Danar Kurniawan As’at Pujianto. 2013. “Perilaku Kuat Tekan Dan Kuat Tarik Beton Campuran Limbah Plastik HDPE.” Semesta Teknika 16(1).
Suratmin, Suratmin, Iman Satyarno, and Kardiyono Tjokrodimuljo. 2007. “Pemanfaatan Kulit Ale-Ale Sebagai Agregat Kasar Dalam Pembuatan Beton.” Pp. 530–38 in Civil Engineering Forum Teknik Sipil. Vol. 17.
Tampubolon, Brave Sugesty. 2020. “Pemanfaatan Limbah Kayu Gelam (Melaleuca Cajuputi) Dan Serbuk Ulin (Eusideroxylon Zwageri) Serta Serbuk Campuran Untuk Pembuatan Papan Semen Partikel.” Jurnal Sylva Scienteae 2(3):432–42.
Umar, Usmanul Hayadi. 2019. “Analisis Kuat Tekan Beton Dengan Serbuk Kayu Jati.” Journal of Civil Engineering and Planning 1(1):20–25.
Wancik, Ahmad, Iman Satyarno, and Kardiyono Tjokrodimuljo. 2008. “Batako Styrofoam Komposit Mortar Semen.” Pp. 780–87 in Civil Engineering Forum Teknik Sipil. Vol. 18.
Winarto, Sigit. 2018. “Pemanfaatan Serat Ijuk Sebagai Material Campuran Dalam Beton Untuk Meningkatkan Kemampuan Beton Menahan Beban Tekan Studi Kasus: Pembangunan Homestay Singonegaran Kediri.” UKaRsT 1(1):1–10.
Wuryati, Samekto, and Rahmadiyanto Candra. 2001. “Teknologi Beton.” Yogyakarta: Kansius.
Authors
Copyright (c) 2024 Elia Anggarini Anggarini, Dyah Pradhitya Hardiani, M. Rizky Maulana Teguh
This work is licensed under a Creative Commons Attribution 4.0 International License.
The use of articles published by this journal is governed by the Creative Commons Attribution license as currently displayed on CC BY 4.0